Omron CJ - 10-2005 Manual page 176

PLC Setup Coding Sheets for Programming Console
150
Address
81 @@@@
Value
PRCN Mode on Programming Console's mode switch
PRG PROGRAM mode
MON MONITOR mode
RUN RUN mode
Note PRCN, PRG, MON, and RUN can be selected
using the Up and Down Keys.
Address
83 @@@@ (CS1D CPU Units for Single-CPU Systems and
CS1-H/CJ1-H CPU Units only)
Value (Hex)
8000 Enabled (Operation will start.)
0000 Disabled (Operation will not start.)
Note These settings are not supported for CS1D
Duplex-CPU Systems.
Address
84 @@@@ (CS1-H CPU Units only)
Value (Hex)
8000 Special Inner Board Setting enabled.
0000 Special Inner Board Setting disabled.
Address
(CS1D CPU Units only)
95@@@@
Value (Hex)
0000
0001
to
4000
Note 1 The secondary unit number is calculated by
adding 1 to the primary unit number.
Note 2 These settings are supported only for
CS1D Duplex-CPU Systems and only for
CSID CPU Unit Ver. 1.1 or later.
Startup mode
RUN enable setting
Special Inner Board Setting
Primary/Secondary Duplex
Communications Unit settings
Not duplex for unit Bits 00 to 14
numbers 0 to 15. correspond to
unit numbers 0
Unit number 0 set
to 14.
as primary Unit.
Unit number 14 set
as primary Unit.
Appendix C