Omron CJ - 10-2005 Manual page 154

File Write
128
DM Area
↑
or
EM Area
↑
or
Parameter Areas (PLC Setup)
↑
or
Note a) When saving I/O memory areas, each area (CIO Area, Holding Bit
Area, Work Area, Auxiliary Area, DM Area or EM Area) is saved to
a separate file (extension .IOM) within the specified word range.
b) Always select DM< when creating a data file that is automatically
transferred when the power is turned ON (AUTOEXEC.IOM).
c) If EM0_ is displayed, input the number of the EM bank from 0 to C.
d) The Parameter Areas include the PLC Setup, registered I/O ta-
bles, routing tables, and CPU Bus Unit Setup.
6. When CIO, HR, WR, AR, DM, or EM@ data is being transferred, specify
the transfer start word address and the transfer end word address.
Transfer start address: CIO 2345
3 4
2
Transfer end address: CIO 2446
4 4
2
WRITE
7. Switch to text input mode to enter the file name.
TEXT
SHIFT
PC~CF_CARD?(IOM)
↓
XFER TYPE
PC~CF_CARD?(IOM)
↓
XFER TYPE
PC~CF_CARD?(STD)
↓
XFER TYPE
PC~CF_CARD? CIO
5
ST 2345 ED 6143
Transfer start address
PC~CF_CARD? CIO
↓
ST 2345 ED
PC~CF_CARD? CIO
6
ST 2345 ED
Transfer end address
PC~CF_CARD?(IOM)
FILE"0:~
0: Memory Card
1: EM File Memory
PC~CF_CARD?(IOM!
!
FILE"0:~
Text input mode
Section 7-3
DM<
EM0_<
STD<
6143
2446
"
"