Omron CJ - 10-2005 Manual page 155

File Write
8. When saving data to a Memory Card, input the file name. When inputting
the name from the Programming Console, A to Z and 0 to 9 are available.
The file name may be a maximum of 8 characters. In the following exam-
ple, the file name is SAMPLE.
*EM_
AA
EM
FUN
EM_/EXT
DM P
LD M
S
A
It is not necessary to input the file extension (.OBJ for UM Area, .IOM for
memory areas within I/O memory, and .STD for Parameter Areas). The ex-
tension will be automatically added.
OBJ (UM area)
CIO, HR, AR, DM, EM@_
STD (PLC Setup)
• Press the Up and Down Keys to move the cursor.
• Change the "0" in the file name to "1" to transfer the file to EM File
Memory instead of to the Memory Card.
• Press the CF/SRCH Key to display the file names already on the Mem-
ory Card or EM File Memory. In this case steps 7, 8, and 9 are not nec-
essary.
9. Return to normal input mode.
10. Execute the save by pressing the WRITE Key.
When a file with the same extension and file name already exists on the
Memory Card, the following display will appear.
11. Use the following procedure to overwrite the existing file on the Memory
Card.
• If you do not want to overwrite the existing file, press the CLR Key and
input a different file name.
• If the volume label or directory name is specified by mistake, a message
will ask if you want to overwrite. If this happens, press the CLR Key and
input the proper file name.
PC~CF_CARD?(IOM!
DR
AR
FILE"0:SAMPLE~ "
IR
HR L
E
Transfer type
CF_CARD~PC?(IOM)
CF
FILE"0:SAMPLE
SRCH
PC~CF_CARD?(IOM)
CLR
FILE"0:SAMPLE~ "
PC~CF_CARD? END
WRITE
FILE"0:SAMPLE
PC~CF_CARD OVER?
FILE"0:SAMPLE
PC~CF_CARD END
WRITE
FILE"0:SAMPLE
Section 7-3
Extension
.OBJ
.IOM
.STD
"
"
"
"
129