Table of Contents
Advertisement
Figure 68. Removing the BOSS-N1 module blank
3. Align the BOSS-N1 module to the BOSS-N1 slot on the chassis and push it into the slot.
4. Using a Phillips 2 screwdriver, secure the BOSS-N1 module to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 69. Installing the BOSS-N1 module
5. Connect the cables to the system board connectors.
NOTE:
Route the cables properly to prevent them from being pinched or crimped.
Installing and removing system components
103
Advertisement
Table of Contents
