Gpu Kit - Dell PowerEdge T360 Installation And Service Manual

GPU kit

The GPU kit is available for the Customer. Depending on the kit ordered, the respective components are available.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated
and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the
system warranty.
WARNING: Consumer-Grade GPU should not be installed or used in the Enterprise Server products.
Table 67. Components in the single width (SW) GPU kit
Components GPU kit
Details
Risers Riser configuration (RC)
1 or 2
Shroud PCI shroud
Fans HPR PCI fan
Heat sinks Standard or
Performance heatsink
based on the processor
wattage
Cables Power cable
FL - Full Length, HL - Half Length, HPR - High Performance, RC - Riser configuration
NOTE: Adding GPUs to a system may increase the power envelope of that configuration beyond the current power supplies
rated capability. Confirm power increase and upgrade PSU as needed to avoid negative impact on performance.
NOTE: See expansion card installation guidelines
Before you begin, follow the
1. Remove the air shroud.
2. Install the GPU, see installing an expansion
NOTE: For information about riser slot location on the system board, see the
section.
3. Install the High performance (HPR) PCI cooling fan.
4. If applicable, connect the power cables to the GPU. To know the connectors for the GPU on the system board, see the
system borard jumpers and connectors
See the GPU power cable matrix to know about the requirement of cables for the GPU.
NOTE: A maximum of one SW GPU is supported on the system.
After installing, follow the
132 Upgrade Kits
Quantity
N/A
1
1
1
NA
safety guidelines and before working inside the system
card.
section.
After working inside the system
for more information about riser configuration supported for the system.
instructions.
instructions.
system borard jumpers and connectors