Removing The Optical Drive - Dell PowerEdge T360 Installation And Service Manual

Figure 35. Installing the optical drive blank into the optical drive cage
Next steps
1. Install the front bezel.
2. Follow the procedure that is listed in

Removing the optical drive

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the front bezel.
4. Disconnect the power and data cables from the optical drive.
NOTE: Ensure that you note the routing of the power and data cable as you remove them from the system board and
drive.
Steps
1. To release the optical drive, press and push the release tab toward the front of the system.
2. Slide the optical drive out of the system.
76 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.