Dell PowerEdge T360 Installation And Service Manual page 43

Table 48. System Security details
Option
CPU AES-NI
Strong Password Status
Strong Password Minimum
Length (8 to 32)
System Password
Setup Password
Password Status
TPM Information
Table 49. TPM 2.0 security information
Option Description
TPM Information
TPM
NOTE:
Security
Enables you to control the reporting mode of the TPM. When set to Off, the presence of the TPM is not
reported to the OS. When set to On, the presence of the TPM is reported to the OS. The TPM Security option
is set to Off by default.
When TPM 2.0 is installed, the TPM Security option is set to On or Off. This option is set to Off by default.
TPM Indicates the type of Trusted Platform Module, if present.
Informatio
n
TPM Indicates the firmware version of the TPM.
Firmware
TPM Enables, disables, or clears the storage and endorsement hierarchies. When set to Enabled, the storage and
Hierarcy endorsement hierarchies can be used.
When set to Disabled, the storage and endorsement hierarchies cannot be used.
When set to Clear, the storage and endorsement hierarchies are cleared of any values, and then reset to
Enabled.
TPM TPM PPI
Advanced Bypass
Settings Provision
TPM PPI
Bypass Clear
TPM2
Algorithm
Selection
Description
Improves the speed of applications by performing encryption and decryption by using
the Advanced Encryption Standard Instruction Set (AES-NI). This option is set to
Enabled by default.
If enabled, you must set up a password that has at least one character in lowercase,
uppercase, digit, and a special character. Also, you have the option to set the minimum
number of characters in both the new passwords. If disabled, you can set a password
that has any character in it but the passwords must not have more than 32 characters.
Changes made by enabling or disabling this feature become immediately effective.
Controls the minimum number of characters used when setting a system or setup
password. You can specify 8-32 characters.
Sets the system password. This option is set to Enabled by default and is read-only if
the password jumper is not installed in the system.
Sets the setup password. This option is read-only if the password jumper is not installed
in the system.
Locks the system password. This option is set to Unlocked by default.
Indicates the type of Trusted Platform Module, if present.
The TPM menu is available only when the TPM module is installed.
When set to Enabled, allows the Operating System to bypass Physical Presence Interface
(PPI) prompts when issuing PPI Advanced Configuration and Power interface (ACPI)
provisioning operations.
When set to Enabled allows the Operating System to bypass Physical Presence Interface
(PPI) prompts when issuing PPI Advanced Configuration and Power Interface (ACPI) clear
operations.
Allows the user to change the cryptographic algorithms used in the Trusted Platform Module
(TPM). The available options are dependent on the TPM firmware.
To enable TPM2 Algorithm Selection, Intel(R) TXT technology must be disabled.
Pre-operating system management applications 43