Dell PowerEdge T360 Installation And Service Manual page 130

NOTE: *The quantity depends on the purchase order.
†
NOTE: The quantity depends on the BOSS-N1 card carrier.
To remove the BOSS blank :
1. Power off the system.
2. Use a screwdriver to push out the blank from the BOSS-N1 module blank.
Figure 99. Removing the BOSS-N1 module blank
To install the BOSS blank:
1. Align the blank with the BOSS-N1 module bay and push it into the bay until it clicks into place.
Figure 100. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. To install the BOSS-N1 module , see
130 Upgrade Kits
Installing the BOSS-N1 card carrier steps 1 to 5.