Installing The Boss-N1 Module - Dell PowerEdge T360 Installation And Service Manual

Figure 67. Installing the BOSS-N1 module blank
5. Using a Phillips 2 screwdriver, tighten the screw that secures the BOSS-N1 module blank to the system.
Next steps
Replace the BOSS-N1 module.

Installing the BOSS-N1 module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
4. If installed, remove the front
Steps
1. Using a Phillips 2 screwdriver, remove the screw that secures the BOSS-N1 module blank from the system.
2. Slide out the BOSS-N1 module blank from the system using a flat head screwdriver.
102 Installing and removing system components
Safety instructions.
Before working inside your system
bezel.
.