Table of Contents
Advertisement
Operation
Figure 8 shows the location of the power indicators on the front and rear panels of the transmitter and receiver.
Front Panel
Front Panel
1
Figure 8.
Power Indicators
Power (and signal) LED (front panel) —
1
Amber — The unit is receiving power, either locally or remotely (on the DTP cable).
Green — The unit is receiving an active HDMI input, either on the HDMI input if a transmitter, or transmitted
on the DTP cable if a receiver.
Power LED (rear panel) —
2
Amber — The unit is receiving power remotely (on the DTP cable).
Green — The unit is receiving power locally.
After the transmitter, the receiver, and their connected devices are powered up, the system is fully operational. If
any problems are encountered, ensure all cables are routed and connected properly.
NOTE: Ensure that the video source and display selected for the DDC are properly connected to the
transmitter and receiver pair, and that the transmitter, the receiver, and the display have power applied
before power is applied to the video source. If the other devices are not turned on before the video source,
the image may not appear.
Rear Panel
Rear Panel
POWER
12V
0.7 A MAX
2
DTP HDMI 4K 230 Tx/Rx Transmitter and Receiver • Installation and Operation
10
Advertisement
Table of Contents
