Table of Contents
Advertisement
Q&A
(continued)
Question
How to adjust the <Position>
The correct shoulder position
cannot be found during scanning
of shoulder roller position.
(The shoulder position slips each
time.)
How to adjust the <Intensity>
The auto course is "Not strong
enough even at the strongest
setting..." or is "Too strong even
at the weakest setting...".
The hip massage is weak ...
I hardly feel any difference in
intensity in the sole roller even
after adjustment ...
Sole roller is too intense even at
the gentlest setting ...
EN46
Correct scanning of shoulder roller position may not be possible
for some sitting positions (such as leaning forward).
Adjust with the shoulder position "▲" and "▼" button.
(EN22 to EN23)
Try the following methods.
ㅡ Maximum intensity is set for a course but the intensity is insufficient.
Leaning back the backrest results in more body weight pressing
against the main unit for stronger massaging.
ㅡ Minimum intensity is set for a course by the intensity is excessive.
Placing cloth or blanket over the backrest can soften the contact
sensation of massage rollers. (EN31)
Cloths and blankets can also be used.
It is easier to work on the hips when the backrest is down. Also,
if you raise the legrest and sit back so that your hips are on the
backrest, the massage roller will be more firmly against the backrest.
If the knees are lifted, the area under the hips will be weakened.
Adjust the angle of the legrest and the slide of the sole part to
prevent the knees from being lifted.
The sole roller intensity is adjusted by the strength of the foot side
air pressure holding the soles.
Therefore, depending on the operating pattern, intensity difference
may not be felt.
Slightly lower the sole massage section so that the heel is raised
above it, which will weaken the effect of the roller.
Answer
Foot side air bag
Advertisement
Table of Contents
