Table of Contents
Advertisement
Question
During operation
The angle of the backrest, legrest
or armrest automatically changes
at times.
You do not want to return
backrest / legrest after timer
expires
Backrest / legrest does not return
after the timer ends
It displayed as not being able to
finish correctly last time...
After use
Red marks are left on the under
side of my hands / arms after a
hand & arm massage.
(continued)
The angle automatically changes in the following cases.
ㅡ While scanning the shoulder roller position
The unit body moves automatically, and gets inclined to the angle
●
If you have adjusted the reclining before use, the angle will not change.
Raises
around 60°
ㅡ When
is pressed to end the massage.
ㅡ When finished by timer
Backrest and legrest will return automatically.
●
If the backrest and legrest angle is set to "Leave in place" in the
settings, it will not return automatically. (EN37)
●
If you exit with
all operations stop on the spot.
●
It may change automatically when performing stretching movements.
If the backrest and legrest angle is set to "Leave in place", the
backrest / legrest will not return automatically after the timer
expires. (EN37)
●
After the timer ends, press the Return the backrest and legrest
displayed on the control panel.
●
If the controller is turned off, press
It is displayed in the following cases
ㅡ Previously shut down due to power outage
ㅡ Stopped by turning the power switch on the back of the main unit
to (○) "OFF" or unplugging the power plug from the outlet before
normal termination operation
Press "OK"
After stowing the backrest or legrest in its original position, resume the
operation.
Marks may remain on the hands and arms after use. These
eventually fade and are not a problem.
Answer
that makes scanning easy.
Reclines around 25°
, the angle does not change automatically and
twice.
Continued on the next page
EN45
Advertisement
Table of Contents
