Table of Contents
Advertisement
Setting up the massage lounger
1
Checking the accessories
Armrests (Left/Right)
Controller stand
and controller
holder are located
on the right
armrest.
Pillow
2
Where to use the unit
Ensure there is adequate space to recline.
Unit body dimensions Height approx. 122 cm × Width* approx. 85 cm × Depth* approx. 200 cm
(See EN53 for detailed unit dimensions.)
* When installing near a wall, etc.
In the reclining state, make sure that the backrest and the legrest are separated from walls, etc., by 10 cm or more,
and the armrest is separated from walls, etc., by 5 cm or more.
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources.
3
This can cause discoloration or hardening of the synthetic leather.
Installing
Always carry
the lounge with at
least two people!
EN10
Left/Right indication (armrest back)
Sole cover
Attached to the
main unit at
purchase.
Place your fingers
in the groove
■ Hold the sides of the legrest.
■ H old the legrest with your
hands until it has been set
on the floor completely.
●
If you release the legrest too
soon, it will spring back to the
initial position.
Comfort
Power cord
cushion
Allen key (1 pc.)
(Cross section)
4 mm
①
The unit must be carried by two or
more persons.
●
Since the unit is heavy, be careful to
avoid back injuries.
Unit weight
Approx. 91 kg
②
Watch your step carefully and put
down the unit slowly.
Lay out a mat, etc.
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the
size of the mat should be sufficient (at
least 130 cm × 70 cm) to cover the areas
where the unit touches and where the
legrest could touch the floor.
Do not hold by the foot
part.
The sole massage section
might slide, and injuries
may occur.
Attachment
screws
(M6×13)
Black
(2 pcs)
Advertisement
Table of Contents
