Panasonic EP-MAN1 Operating Instructions Manual page 44

(household) massage lounger
Table of Contents

Advertisement

Q&A
(continued)
Question
During operation
During shoulder scanning or a
massage, 7 short beeps sounded
(
was displayed) and the
action stopped. What happened?
The mechanical intensity
adjustment button for the upper
half of the body does not work
sometimes.
There is a delay in movement
when adjusting the position.
The height (intensity) on the left
feels different to that on the right.
The massage rollers sometimes
move bit by bit in a twitching
manner.
The sole roller sometimes moves
before the course begins...
During auto course (including
memory course), air action and
sole roller action may suddenly
stop and transit to the next
operation...
Can you do hand/arm massage
on both sides at the same time?
EN44
Massages stop for safety if the body cannot be detected for one of
the following reasons.
ㅡ The user is not sitting.

ㅡ The head and / or back is not touching the backrest.

ㅡ A cushion is placed against the backrest or the user is wearing thick

clothing.
ㅡ The comfort cushion is not raised.

Sit firmly, lean gently back so that your head touches the pillow, press
and then press
The upper body massage roller intensity button is ineffective
in following instances. The intensity display flashes during
adjustment. No adjustments will be accepted while it is flashing.
This is an intentional condition to prevent suddenly intensifying strength
and is not a malfunction.
The massage rollers may not move immediately depending on
when the position button is pushed. (There may be a small time
lag. This is not an abnormality.)
If you hear the limit sound (beep-beep-beep) when the button is
pushed, this means that it is at the furthest position and cannot move
any further.
It is designed to differ in some cases.
An alternating tapping mechanism is used to create a more natural
sensation. The massage rollers therefore do not move in unison in
some massages. The massage roller height (intensity) on the left differs
from that on the right in these massages. This is not a malfunction.
The chair is detecting the pressure acting on the massage rollers
and changing the massage strength.
The massage rollers may move bit by bit depending on the
pressure but this is not an abnormality.
Before the course begins, the sole roller moves into place.
This is not an abnormality.
When hip massage or stretching operations start during an
Automatic course, the supply of air used for operations and sole
roller movements are suspended.
This is due to the priority on the air motion that is linked to
movements of rollers to enhance the effectiveness of hip massage
or stretching operations.
For this reason, in the number of times arm massage is performed
on the left and the right may differ with alternated application of
pressure for air arm massage.
The massage alternates between left and right so that it can stop
immediately when it senses abnormality or danger.
Answer
to start again.

Advertisement

Table of Contents
loading

Table of Contents