Resetting The Printer - Tektronix Phaser 740 Network Manual

Chapter
16
Resetting the printer: PhaserLink Printer Management
Software

Resetting the Printer

Several of the network configuration procedures require you to reset the printer.
There are several ways to reset the printer:
Turn the printer off, then back on again.
With a TCP/IP connection and a World Wide Web browser, you can use
PhaserLink Printer Management Software; see "Resetting the printer:
PhaserLink Printer Management Software" on page 169.
PC and UNIX users can send the PostScript file RESET.PS from the
printer's utilities software.
Macintosh users can reset the printer using the Apple Printer Utility. See
"Resetting your printer using the Apple Printer Utility" on page 170.
Resetting the printer by any of these methods restores the printer to its power-on
conditions (not its factory default conditions). The power-on conditions include any
custom changes made to the printer that are stored in the printer's non-volatile
memory and are therefore persistent across printer power cycles. For example, the
printer's name is a power-on condition that is not altered by resetting the printer.
1.
From the printer's home page, click Configuration; this displays the View
and Configure Settings page.
2.
On the View and Configure Settings page, click Configure Authorization
Codes.
3.
On the Configure Authorization Codes page, enter the validation
password (if one has been assigned), and click Do/Apply.
N
O T E
PhaserLink passwords are not encrypted.
4.
Wait 10 seconds, then click the browser's Stop button.
5.
Reload the page in the browser.
For more information on PhaserLink Printer Management Software, see Chapter 12,
"PhaserLink Printer Management Software".
PhaserShare Networking Manual
169