Tektronix Phaser 740 Network Manual page 119

Creating an AppleTalk port
1.
In the Printer Port dialog box, double-click the AppleTalk Printing
Devices port. If the AppleTalk Printing Devices port is not listed in the
Printer Port dialog box, the Microsoft Services for Macintosh needs to be
added to the Windows NT machine:
a.
In Control Panel, double-click Network; the Network Settings dialog
box appears.
b.
In the Network Settings dialog box, click Add Software; the Add
Network Software dialog box appears.
c.
In the Add Network Software dialog box, click the drop down menu
for Network Software. In the list, select Services for Macintosh, then
click OK to install the service. The original Windows NT distribution
diskettes are needed during installation. To apply these changes,
restart Windows NT.
2.
In the Available AppleTalk Printing Devices dialog box, select the zone
where the printer resides. If no zone name appears, double-click the zone
icon.
3.
Windows NT searches for all AppleTalk devices in that zone and displays a
list; double click your printer.
4.
Windows NT prompts you to capture the printer; click No. (Capturing the
printer causes it to disappear from the Chooser.)
Set up sharing
If this printer is to be shared on the network, perform the following steps:
1.
In the Create Printer dialog box, check the option Share this printer on the
network.
2.
Enter any name you want for the Share Name.
PhaserShare Networking Manual
10
Windows NT
111