Tektronix Phaser 740 Network Manual page 169

Phaser 740 printer
6. To disable TCP/IP:
a.
Press the down-arrow button until TCP/IP is highlighted. Press
Select.
b.
Press the down-arrow button until TCP/IP Interface is
highlighted.
c.
Press Select until Off is displayed.
To return the printer to normal operation, press the down-arrow
button until Exit is highlighted. Press Select.
To disable other protocols, press the up-arrow button until
Previous Menu is highlighted. Press Select. Continue with
Step 7.
7. To disable HTTP:
a.
Press the down-arrow button until HTTP is highlighted.
b.
Press Select until Off is displayed.
c.
To return the printer to normal operation, press the down-arrow button
until Exit is highlighted. Press Select.
1.
Press Menu; the front panel displays Help Pages.
N
O T E
When you are in the menu, if the front panel is not used for 5 minutes, the
printer returns to the Ready
2.
Enter the Network Settings menu by pressing ----> or <---- until
the front panel displays Network Settings.
3.
Press Menu; the front panel displays TCP/IP.
4. Disabling TCP/IP:
a.
Press Menu; the front panel displays Interface.
b.
Press Menu again to display the current status of the protocol:
Interface:Enabled or Interface:Disabled. The current status
is marked with an asterisk (*) in the upper-right corner of the display.
c.
Press ----> until the front panel displays Interface:Disabled.
d.
Press OK to disable the protocol; the front panel briefly displays
Selected, then it displays Interface.
e.
Press Exit (the far left button) to return to the TCP/IP display.
state.
PhaserShare Networking Manual
15
Disabling Protocols
161