Tektronix Phaser 740 Network Manual page 25

Setting Frame Routing from the Phaser 780 printer front panel
When the Token Ring card is installed in the printer, you can set the Frame Routing
from the printer's front panel. The choices are Transparent (no source routing) or
Source Route (use source routing).
1.
While Ready is displayed, press Select; the Printer menu is displayed:
Printer Menu
Help Pages
2.
Press the left or right arrow buttons until the front panel displays Network
Settings.
Printer Menu
Network Settings
3.
Press Menu to enter the Network Settings menu; the front panel
displays:
Network Settings
Token Ring
4.
Press Menu again; the front panel displays the first of two Frame Routing
choices.
5.
Select the desired Frame Routing: Transparent or Source Route:
a.
Press the right arrow button until the Frame Routing choice you want
is displayed.
b.
Press Select to enter your choice into the printer; the front panel
briefly displays Selected, then displays the selected Frame Routing
choice again.
6.
Return the printer to normal operation:
a.
P ress Exit (the far right button) until the front panel displays:
Network Settings
Token Ring
b. Exit again.
Press
If you have changed any parameters that require a printer reset to take
effect, you will be prompted to reset the printer. If you press Confirm,
the printer resets. To return to normal operation without resetting the
printer, press
the top line of the display. Press
normal operation, but the changes you have made will not take effect
until the next time the printer is reset.
If you have not changed any parameters that require a printer reset,
Exit again; the front panel displays Ready.
press
PhaserShare Series B Network Interfaces
Menu
Menu
Menu
Menu
Exit (the far right button) ; Printer Menu appears on
Exit again; the printer returns to
PhaserShare Networking Manual
2
17