Tektronix Phaser 740 Network Manual page 172
Phasershare series b network interface
Hide thumbs
Also See for Phaser 740:
- Service manual (148 pages) ,
- Setup manual (82 pages) ,
- User manual (44 pages)
Table of Contents
Advertisement
15
Disabling Protocols
164
PhaserShare Networking Manual
6.
Disabling NetWare:
To return the printer to normal operation, go
immediately to Step 8; to continue and disable the NetWare protocol,
follow these steps:
a.
Press the right arrow button until the front panel displays NetWare.
b.
Press Menu; the front panel displays Interface.
c.
Press Menu again to display the current status of the protocol: On or
Off. The current status is marked with an asterisk (*) in the
upper-right corner of the display.
d.
Press the right arrow button until the front panel displays Off.
e.
Press Select to disable the protocol; the front panel briefly displays
Selected, then it displays Off again.
f.
Press Exit (the far right button) twice to return to the Network
Settings menu.
7.
Disabling HTTP:
To return the printer to normal operation, go immediately
to Step 8; to continue and disable the HTTP protocol, follow these steps:
a.
Press the right arrow button until the front panel displays HTTP.
b.
Press Menu to display the current status of the protocol: On or Off.
The current status is marked with an asterisk (*) in the upper-right
corner of the display.
c.
Press the right arrow button until the front panel displays Off.
d.
Press Select to disable the protocol; the front panel briefly displays
Selected, then it displays Off again.
e.
Press Exit (the far right button) twice to return to the Network
Settings menu.
8.
Return the printer to normal operation, press Exit (the far right button)
again:
If you have changed any parameters that require a printer reset to take
effect, you will be prompted to reset the printer. If you press Reset,
the printer resets. If you press Resume, the front panel displays
Network Settings. Press Exit (the far right button); the printer
returns to normal operation, but the changes you have made will not
take effect until the next time the printer is reset.
If you have not changed any parameters that require a printer reset to
take effect, the front panel displays Ready.
Advertisement
Table of Contents
Troubleshooting
