Raw TCP/IP Printing
Use these instructions to enable or disable Raw Printing using CentreWare Internet Services.
Installation Procedure
There are two stages required to install the device on an Raw TCP/IP printing network using
CentreWare Internet Services:
Configure the WorkCentre 4118 / FaxCentre 2218
Test Print
Configure the WorkCentre 4118 / FaxCentre 2218
To complete the installation of the WorkCentre 4118 / FaxCentre 2218, perform these steps:
Open CentreWare Internet Services (see Accessing CentreWare Internet Services on
1
page 7-4).
At the CentreWare Internet Services Home Page for the WorkCentre 4118 / FaxCentre
2
2218, select the [Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
3
then select the [+] symbol to the left of the Protocols folder.
Select [Raw TCP/IP Printing].
4
Select the checkbox to enable Raw TCP/IP Printing.
Enter the required port number.
NOTE: While you can change the port number at which the WorkCentre 4118 / FaxCentre
2218 will accept RAW print jobs, it is recommended that you use the default port, 9100. this is
the industry standard
Click the [Apply] button to implement any changes.
5
NOTE: Click the [Undo] button to cancel any changes made and return to the previous
values.
Page 7-16
This procedure explains how to use CentreWare Internet Services to
configure the device.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide