Checking Configurations - Xerox FaxCentre 2218 System Administration Manual

Click the [Apply] button to implement any changes.
5
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
Select the [Status] tab and then select [Reboot Machine] to enable the selection to take
6
effect.

Checking Configurations

Use these instructions to check the configuration settings of the WorkCentre 4118 / FaxCentre
2218.
To check the configuration, perform these steps:
Open CentreWare Internet Services (see "Accessing CentreWare Internet Services" on
1
page 10-6).
At the CentreWare Internet Services Home Page for the WorkCentre 4118 / FaxCentre
2
2218, select the [Properties] tab.
Select the plus symbol [+] to the left of the General Setup folder in the Properties frame.
3
In the Properties frame, within the General Setup folder, select [Configuration].
4
The lower pane will show the firmware versions.
Click [Print System Data List] to print this report.
In the upper pane, click the link for the settings that you want to check.
5
Page 10-8 Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide