Ssdp - Xerox FaxCentre 2218 System Administration Manual

SSDP

Use these instructions to configure the Simple Service Discovery Protocol (SSDP) using
CentreWare Internet Services.
Configure SSDP
To configure SSDP, perform these steps:
Open CentreWare Internet Services (see Accessing CentreWare Internet Services on
1
page 7-4).
At the CentreWare Internet Services Home Page for the WorkCentre 4118 / FaxCentre
2
2218, select the [Properties] link.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and
3
then select the [+] symbol to the left of the Protocols folder.
Select [SSDP] and check the Protocol Configuration details are correct. If any of the
4
details are incorrect then enter the correct information.
Make the following selections and settings in the General section of the Protocols frame:
5
Select the checkbox to enable SSDP.
Enter the [Time to Live] (1 to 255 hops).
Click the [Apply] button to implement any changes.
6
NOTE: Click the [Undo] button to cancel any changes made and return to the previous
values.
Select the [Status] tab and then select [Reboot Machine] to enable the selections to take
7
effect.
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide Page 7-13