Mounting The Monitor - Eizo CuratOR LX550W Instructions For Use Manual

4.3 Mounting the monitor

The monitor has a VESA 400 x 400 adapter and can be installed in a suitable ceiling sus-
pension or wall mount.
Observe the following during installation:
• The maximum torque for attaching to the holder is 15 Nm.
• The screws used for attaching to the holder must meet the following requirements:
Number
Thread
Strength
Insertion depth
CAUTION
Installation
• To ensure even load distribution, insert and tighten all four screws before placing a load
on the screws.
• Irreparable damage to the monitor may result from exceeding the maximum torque for
attaching the holder.
• Using screws that are too short or too long could result in instability or damage to the
monitor.
CAUTION
Holders
• Mounts must be tested and approved by the manufacturer for the weight to be sup-
ported.
• An installed stand must be sufficiently stable to withstand tilting of up to 10° without top-
pling the monitor.
CuratOR LX550W
Instructions for Use, 04/2021
4.3 Mounting the monitor
4
M8
8.8 in accordance with ISO 898-1
16 - 20 mm
Setup and installation
17