Operation
7.3 Description of OSD menu
Function
LED Timeout
Service
7.3.4 Information menu
Display (Example)
P/N 6GF6200-8BA00
S/N 1000000####
AN ########
Working Hours 151
Temperature (°C) 25
Firmware 4.161
FPGA 1.023
OSD 3.002
34
Values
No Timeout
Timeout (min) 1
Backlight Sensor Test
System Mode
Reset to Factory Defaults
Description
Selecting this menu displays the following information regard-
ing the monitor:
•
Product number P/N
•
Serial number S/N
•
Asset number A/N
•
Operating hours
•
Temperature in the device
•
Installed firmware, FPGA, and OSD version.
Description
Setting the operation LED timeout
You can set a set wait time (in minutes) after which
the operation LED is switched off to prevent inter-
fering stray light.
Note: The operation LED switches on again auto-
matically when an error occurs in the monitor. The
color of the operation LED then indicates a possi-
ble
cause of the error
[} 39].
Backlight Sensor Test
When you select this function, a series of bright-
ness settings is checked using the internal sensor.
•
The these values differ from the defaults, the
message "Check with QA SW" is displayed.
You can recalibrate the sensor using the QA
software.
•
If the values do not differ from the defaults,
"Normal" status is displayed.
System Mode
Set the mode in which the monitor is to operate.
•
In "Compatible Mode", DVI is the default video
input.
•
In "Universal Mode", DisplayPort is the default
video input.
See also
Description of the connection procedure
[} 23].
Reset to Factory Defaults
Selecting this function opens a dialog box where
you can reset the device to the factory settings.
Instructions for Use, 04/2021
CuratOR LX550W