Mounting The Monitor - Eizo CuratOR EX5841 Instructions For Use Manual

4.3 Mounting the monitor

CAUTION
Installation
• To enable an even load distribution, all screws have to be inserted and tightened before
placing the screws under load.
• Exceeding the maximum torque for attachment on the holder can cause irreparable
damage to the monitor.
• Using screws that are too long or too short can result in instability or damage the moni-
tor.
CAUTION
Holders
• Mounts must be tested and approved by the manufacturer for the weight to be sup-
ported.
• An installed stand must be sufficiently stable to withstand tilting of up to 10° without top-
pling the monitor.
Fig.: Back view with threaded holes for VESA holder
The monitor has a VESA 400x200 or VESA 400x400 mounting interface and can be in-
stalled in a suitable ceiling suspension or wall mount.
Four screws are preinstalled for mounting in a VESA 400x400 holder.
Note
Mounting the monitor in a holder other than the VESA 400x400
If the monitor is to be mounted in a holder other than a VESA 400x400, remove the prein-
stalled screws and cover the screw holes with the adhesive foil included in the scope of
delivery. Otherwise, protection class IP32 cannot be maintained.
CuratOR EX5841
Instructions for Use, 04/2020
M8 threaded holes
Setup and installation
4.3 Mounting the monitor
17