Table of Contents
Advertisement
Function
Adjust LUT
Note: Open the func-
tion by selecting a LUT
under "CAL Switch"
and pressing "Enter".
Model
Gamma Function
Mode Presets
CuratOR LX550W
Instructions for Use, 04/2021
Values
Model
2
Lum Max [cd/m
]
2
Lum Min [cd/m
]
2
Lum Ambient [cd/m
]
Color Calibration
X
Y
CIE1976
CIE (DIN 6174)
CRT
DICOM
Gamma Function
Log.Lum.Linear
Native
2.0
2.2
2.5
2.7
3.0
3.3
"0" or "1 per LUT
7.3 Description of OSD menu
Description
Adjust LUT
Here you can adjust the model and the color and
brightness settings of the selected LUT.
CAUTION: All values may only be changed by
service personnel. Otherwise, the intended use
of the device is no longer ensured.
•
Lum Max: Set brightness for fully white.
•
Lum Min: Set value for black.
•
Lum Ambient: Set value for ambient bright-
ness.
•
Color Calibration: Cannot be changed. Set to
Yes.
•
X, Y: Color coordinate setting. These coordi-
nates can be changed incrementally.
Note: After each parameter change, the LUT in
the device is immediately recalculated.
Note: Parameter changes must be saved. Other-
wise, the settings will be lost when switching off.
Set the gamma model
The gamma model, which serves as the basis for
recalculating the LUT, can be set here.
Select the gamma function
Setting the Mode Preset
This function enables you to make any LUT set-
tings in the "CAL Switch" function selectable (1)
or non-selectable (0).
The names of the selectable LUT settings are
taken from the "CAL Switch" function.
Note: An active LUT setting cannot be replaced.
Operation
31
Advertisement
Table of Contents
