Table of Contents
Advertisement
- If swallowed and person is conscious,
rinse mouth with water for at least 15
minutes . Do not induce vomiting unless
instructed to do so by medical professio-
nal. Get medical attention immediately .
(D
Note
Liquid electrolyte leaking from broken mir-
ror glass will damage any plastic surfaces
it comes in contact with . Clean up spilled
electrolyte immediately with clean water
and a sponge.
@
Tips
- Switching off the dimming function of
the inside rear view mirror also deacti-
vates the automatic dimm ing function of
the exterior mirrors .
-Automatic dimming for the mirror only
operates properly if the light striking the
inside mirror is not hindered by other ob-
jects.
- The automatic dimming mirrors do not
dim when the interior lighting is turned
on or the reverse gear is selected .
Sun visors
._[ _ __,!
Fig. 63
Driver's s ide: sun visor
The sun visors for the driver and passenger
can be pulled out of their brackets in the cen-
ter of the vehicle and turned towards the
doors
(D.
The mirror light switches on when the cover
over the vanity mirror @ opens .
Clear
vision
5 7
Wiper
and washer
system
Switching the windshield wipers on
Fig. 64
Windshield wipe r leve r
Move the windshield wiper lever to the corre-
sponding position:
@ -
Windshield wiper off
CD -
Interval mode . To extend/shorten the
wiper intervals, move the switch @ to the
left/right. In vehicles with a rain sensor* the
wipers t urn on in the rain once the vehicle
speed exceeds approximately 2 mph (4 km/h) .
The higher the sensitivity of the rain sensor* is
set (switch @ to the right), the earlier the
windshield wipers react to moisture on the
windshield. In some models, you can switch
rain sensor mode off and switch intermittent
mode on in the MMI*. Select:
!CAR I
function
button
>
Car systems*
control button
>
Driver
assist
>
Rain sensor.
In intermittent mode,
you can adjust t he interval time using the @
switch.
@ - Slow wiping
® -
Fast wiping
© -
Single wipe
® - Clean the windshield. To eliminate water
droplets, the windshield wiper performs one
afterwipe operation after several seconds
while driving . You can switch this function off
by moving the lever to position ® within 10
seconds of the afterwipe operation. The after-
wipe function is reactivated the next time the
ignition is switched on.
...
Advertisement
Table of Contents
