Table of Contents
Advertisement
(D
Tips
- The light sensor* for headl ight control is
located in the rear view m irror mount.
You should therefore not apply any st ick-
ers to the windsh ield in this area in order
to prevent malfunctions or failures .
- Some exterior lighting functions can be
adjusted
¢ page 53.
- When yo u remove your key from the igni-
tion w hile the vehicle's lights are turned
on, a buzzer sounds as long as the driv-
er's door is open.
- In cool or damp weather, t he inside of
the headlights, t urn signa ls and tail
lights can fog over due to the tem pera-
ture diffe rence betwe en t he inside and
outside. They will clear shor t ly after
switc hing t hem on. This does not aff ect
the service life of t he ligh t ing.
- In t he event of a light sensor malfunc-
tion, the driver is not ifie d in t he inst ru-
ment cluster display ~
page 22 .
Turn signals and high beam lever
The lever operates the turn signal s, the high
beams and the headlight flasher .
Fig. 56 Turn sig nal and high beam lever
Turn signals
¢i ¢
The turn signals activate when you move the
lever into a turn signal position when the ign i-
tion is switched on.
(D -
right turn signal
@ -
Left tu rn signa l
The turn signal bli nks three times if you just
tap the lever.
Clear
vi sion
5 3
High beams and headlight flasher
@:D
Move the lever to the corresponding posit ion:
@ -
high beams on
@ -
high beams off or headlight flasher
The ind icator light
II
in the instr ument clus-
ter turns on .
Notes on these features
- The
turn signals
on ly wor k w it h t he ignition
t urned on. The indicat or light s
11
or
II
in
the instrument cluste r also blink .
- Aft er you have tu rned a corner, t he turn sig-
nal swit ches off autom at ically .
- The
high beam
wo rks only when the head-
lights are on. The indicator L ight.
in t he
instrumen t cluster illuminates when the
high beams are on .
- The
headligh t flasher
works on ly as long as
you hold the lever - even if the re are no
lights switched on. The ind icator light
Ill
in
the inst rument cluster illuminates when you
use the headlight flasher.
&_
WARNING
Do not use the high beam or headlight
flasher if you know that these could blin d
oncom ing traffic.
Adjusting exterior lighting
The functions are selected in the radio or
MM!* .
.. Select:
!CAR I
function button> Exterior
light ing.
Or
.. Select:
!CAR I
function button > Car systems*
cont rol butto n > Vehicle settings
>
Exterior
lighting .
Coming home (light when leaving car) *,
Leaving home (light when unlocking car)*
The coming home function illumi nates the
area around the vehicle when the ignition is
switched off and the drive r's door is open ed.
Depending on vehicle equipment, t he fu nction
can be switched on and off or t he length of
time the lights remain on* can be adju sted .
.._
Advertisement
Table of Contents
