Table of Contents
Advertisement
234
T i re s and w heel s
contribution to good road holding and safe
handling when in good condition and properly
inflated
¢
,& .
We recommend that all work on tires and
wheels be perfo rmed by an authorized Audi
dealer. They are familiar with recommended
proced ures and have the necessary special
too ls and spare parts as well as the proper fa-
cilities for disposing of the old tires.
Authorized Audi dealers have the necessary
information about techn ical requ irements for
installing or changing tires and rims.
Replacing t ires and w heels
Tires should be rep laced at least in pairs and
not individua lly (for examp le both front tires
or both rear tires together).
Be sure to read and heed the information to
the tire pressure monitoring system*
¢page 240.
Always buy rep lacement radial tires that have
the same specifications as the ti res approved
for your vehicle by Audi. Replacement t ires
must always have the same load rating speci-
fication as the original equipment or approved
optional tires listed in the table
c:>
page 226.
Audi-approved specification ti res are specially
matched to your vehicle and its load limits,
and can contribute to the important road hold-
ing, driving characteristics, and safety of the
vehicle. The table (c:>page 226) lists specifica-
tions of the t ires approved for the Audi mod-
els covered by your Owner's Literature .
The tire pressure label located on driver's side
B-pillar (c:>page 226, fig. 186) lists the speci-
f ications of the orig inal equipment tires in-
stalled on your veh icle at the time it was man-
ufactured.
Federal law requires t ire manufacturers to
place standard ized information on the side-
wall of all tires c:> fig. 189 . This information
ident ifies and describes the fundamental
characterist ics, the quality grade of the tire
and also provides a tire ident ificat ion number
f or saf ety standard certification and in case of
a recall.
Tire specifications
Knowledge of ti re specificat ions makes it eas-
ier to choose the correct tires. Radial ti res
have the tire specifications marked on the
sidewa ll , for examp le:
P265 / 35 R19 98Y XL
This conta ins the following information:
P
Indicates the t ire is for passenger cars
(where app licable)
265 Nominal tire width in mm of the tire
from sidewall edge to sidewa ll edge. In
general, the larger the number, the wider
the tire
35 Height/w idth ratio in percent (aspect ra-
t io)
R
Tire construction: Radial
19 Rim diameter code (in inches)
98 Load rating code
Y
Speed rat ing letter code
XL
(or "xl", "EXTRA LOAD", or "RF" I ndicates
t hat t he t ire is a"Reinforced" or an " Extra
Load" t ire
M+S (or "M/S") I ndicates that the tire has
some mud and snow capabi lity
The tires could also have the information of
direction of rotat ion
c:>
page 222 .
Tire manufacturing date
The manufact uring date is also indicated on
the tire sidewall (possibly on ly on the inner
side of the wheel) :
"DOT ... 2212 ... "means, for examp le, that
the tire was produced in the 22nd week of
2012.
Speed rating (letter code)
The speed rating letter code on the whee ls in-
dicates the maximum permissible road speeds
c:>
&
in Winter tires on page 238 .
P
up to 93 mph (150 km/h)
Q
up to 99 mp h (158 km/h)
R
up to 106 mph (170 km/h)
Advertisement
Table of Contents
