Table of Contents
Advertisement
EFFECTS SELECT section
MIX (mixing) button
j
Press to mix the A bus and B bus pictures with the EFF lever.
The button will light.
WIPE/SHIFT button
Press to wipe the A bus picture with the B bus picture or vice
versa with the EFF lever.
When this button is pressed once, the button and the upper
left button light and the wipe patter is selected by the wipe
pattern select buttons.
When the button is pressed again, the figures appear on the
pattern code indication window, and the lower right M button
starts blinking. In this condition, the wipe pattern is selected
by the pattern code of three digits. The upper two-row buttons
of the wipe pattern select buttons function to designate the
pattern code.
_—-- EXT KEY (extemal key) button
Press to key the A bus and B bus pictures using the input
Signal from the EXT KEY connector. The button will light.
lL caseaeed Patter code indication window
When the wipe pattern is designated by the pattern code, the
code number is displayed here. Display the code number by
pressing the WIPE/SHIFT button, and designate the pattern
code,
—___—--~ Wipe pattem select buttons
Press to select the wipe pattern to be used. There are two
methods to select a wipe pattern. One is to select the pattern
Corresponds to
by pressing the appropriate button, and the pattern printed on
each digit
the button is selected.
Press to increase
The other is to select the pattern by designating the pattern
the figure.
code of three digits. Set the figures in the pattern code
;
indication window by pressing the upper two-row buttons,
Press to decrease
then press the M button. And the pattern whose pattern code
the figure.
is displayed in the window is selected. As for the pattern
Press to settle the
code, refer to "TABLE OF WIPE PATTERNS".
pattern code,
The above two methods are cyclically changed every time the
WIPE/SHIFT button is presed.
51
Advertisement
Table of Contents
