Table of Contents
Advertisement
ADJUSTING THE TORQUE OF
LEVERS
The torque of the PGM/PST MIX and EFF levers can be
adjusted. Adjust the TORQUE screw on the right side at the
base of the lever with a screwdriver.
® The video and setup level of signals output from the PST
OUT and PGM OUT connectors can be adjusted. While
monitoring the waveform on the waveform monitor, adjust
the level by the PST VIDEO, PST SETUP, PGM VIDEO and
PGM SETUP volumes on the 3 EF-13 board.
¢ The setup level of the A bus and the B bus, when making a
"Wipe effect", can be adjustedand equalized with the A/B
BAL volume on the same board, While monitoring their
waveforms, turn the control so that the waveforms
coincide.
To adjust the video level of preset output
To adjust the setup level of preset output
To adjust the setup level of A bus and 8 bus
when making a "Wipe effect".
On the buttons to select a picture, labels indicating the video
signal sources (supplied) can be attached as follows.
ADJUSTING THE INTERCOM AND SIDE TONE
LEVELS
The intercom level of intercom 5 through 8 and the side tone
level of intercom 1 through 8 canbe adjusted with the
volumes placed below the contro! panel.
To adjust the side tone of intercom 5 through 8
To adjust the intercom level of intercom 5 through 8
Button
To adjust the side tone of intercom 1 through 4
1 Remove the plastic cover on the button.
2 Put the label (supplied) on top of the button.
3 Replace the plastic cover.
44
Advertisement
Table of Contents
