Presetting Manufacture Codes - Pioneer PDP-5040HD Operating Instructions Manual

÷
_Usefum Features
Learning function of the remote
controU unit
You can operate the connected AV products (AV Re-
ceiver. Cable Box SAT tuneis VCR, DVD, DVD recorder,
LD) using the learning function of your remote control
unit. This remote control unit has a function that can
memorize each remote control code.
2 to 5 cm (0.8 to 2.0 inches)
NOTE
1:oexit the Edit mode halfway, press EDiT/LEARN
If the Mode switch selection is changed when in the
Edit mode, the Edit mode is cancelled.
If no operation is performed for more than one
minute, the Edit mode is cancelled.
When you enter a code not listed, the LED flashes
If the table on page 99 does not include your desired
rnanufacturer or the remote control does not work,
you can make the memory learn its signal by the
Learn mode.
The initial mode is "000" (PIONEER).
@ii;iiBiiiiiiiWi_iWi_iWi_i ¸,
m
/////////////////////////////////////////
Remote control
(Supplied accessory)
Remote control of
AV product
÷
Presetting manufacture codes
1 Slide tl_e Mode switch to matcl_ tl_e device to
wl_icl_ you want to preset tl_e remote control
signal.
2 Press EDmT/LEARN and I at tl_e same time.
• Tl_e LED flasl_es.
3 Press e- 9 to enter tl_e manufacture code. See
page 99.
, Preset mode is finisl_ed once tl_e LED no longer
ligl_ts up.
÷
En
PDP5040HD=Eng (97-105) 97 _ 7/24/03, 2:01 PM