Setting Up For Klink Standby - Pioneer PDP-5040HD Operating Instructions Manual

÷
Enjoying through E×ternam Equipment
To delete information about all devices:
1 Press ÷/,1, to seUect "DeUete AH", and then press
ENTER,
2 Press ÷/-I, to seUect "DeUete" and then press
ENTER.
OSD
Setting up for i,UNK standby
Use the following procedure to enabb data transfer
between multipb i.LINK devices even when the system
is in the standby mode.
t Press HOME MENU.
2 Press 4,/_1,to select "DTV Setup", and then press
ENTER.
3 Press 4"/+ to select "i.LINK Setup", and then
press ENTER.
4 Press 4,/÷ to select "i.MNK Standby", and then
press ENTER.
5 Press 4,/+ to select "Enable", and then press
ENTER.
3
A confirmation message appears.
A warning message appears if the selected
device has been preset for recording with the
timer or if its power is on. If you delete a device
that has been preset for recording, its all
presettings are deleted.
Press ÷/-_ to select "OK", and then press ENTER.
OSD
OSO
6 Press HOIVIE MENU to exit the menu.
NOTE
With "Enable" selected, the system relays data
between multiple i.LINK devices even when in the
standby mode', the i.LINK circuits are energized in
that mode.
With "Disable" (factory default) selected, less power
is consumed when the system is in the standby
mode: however the system does not relay data
between multipb i.LINK devices. When i.LINK de-
vices are not in connection, select "Disable", result-
ing in less power consumption.
in standby mode
i.LINKdevice Media Receiver
No data relay
i.LlNK device
÷
ER
PDP5040HD-Eng (65-80) 76 _ 7/24/03, 2:00 PM