Connecting Other Audio Equipment; Connecting An Av Receiver - Pioneer PDP-5040HD Operating Instructions Manual

÷
Enjoying through E×ternam Equipment
Connecting other audio equipment
The digital audio eutput terminal (optical) on this
system can output Dolby Digital signals. Using an
optical digital cable, connect an AV receiver to the
digital audio output terminal (optical) on the rear of the
Media Receiver. This allows audio such as digital TV
broadcasting to be played in high quality.
Connecting an AV receiver
media Receiver (rear view)
If your AV receiver does not have a digital audio input
terminal (optical), connect the MONITOR OUT termi-
nals (AUDIO) on the rear of the Media Receiver to the
audio input terminals on the AV receiver.
_"_ NOTE
When using the digital audio output terminal (opti-
cal), you need to make settings depending on your AV
receiver. For more information, see the user's manual
for the AV receiver,
_iiiiiii_ii_i;i1_iiiiiiiiii1iii_iii_ ¸,
m
Audio cable
(comrnercially available)
÷
Optical digital cable
(commercially available) ÷
AV receiver
Switching the opticaU audio signaU
type
Set up for the DIGITAL AUDIO output terminal (OPTI-
CAL), dependir_g on your AV receiver,
I
Press HOmE mENU.
2 Press÷/÷to select "DTV Setup", and then press
ENTER
3 Press ÷/4, to select "Digital Audio Out", and tl_en
press ENTER.
4 Press +/4, to select "Dolby Digital" or "PCM", and
tl_en press ENTER.
OSD
PCM Always outputs in the PCM format
(factory default) regardless of the types of signaK
Dolby Digital
For Dolby Digital encoded signals, outputs
in the Dolby Digital format For PCM
encoded signals, outputs in the PCM
format.
5 Press HOmE mENU to exit the menu.
En
PDP504OHD-Eng (65-80) 69 _ 7/24/03, 2:00 PM