Table of Contents
Advertisement
• FQXSFPU0031N: The number of POST attempts has reached the value configured in F1 setup.The
system has booted with default UEFI settings. User specified settings have been preserved and will
be used on subsequent boots unless modified before rebooting.
Severity: Error
User Action:
Complete the following steps:
1. Original UEFI settings are still present. If customer desires to continue using the original settings,
select Save Settings.
2. If User did not intentionally trigger the reboots, check logs for probable cause. For example, if there
is a battery fault event, follow the steps to resolve that event.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-
install options one at a time to locate the problem.
4. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to this
error. Update UEFI firmware if applicable.
5. Save customer's UEFI configurations, then remove and re-install CMOS battery for 30 seconds to
clear CMOS contents. If it boots successfully, then restore system settings.
6. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU4033F: TPM Firmware recovery is in progress. Please DO NOT power off or reset system.
Severity: Warning
User Action:
Information only; no action is required.
Note: The system will not respond to power off signal (FQXSFPU4034I) while TPM firmware recovery in
progress.
• FQXSFPU4034I: TPM Firmware recovery is finished, rebooting system to take effect.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4035M: TPM Firmware recovery failed. TPM chip may be damaged.
Severity: Warning
User Action:
.
159
Chapter 3
UEFI events
Advertisement
Table of Contents
