Lenovo 7DCE Messages Manual page 150

Table 3. Events organized by severity (continued)
Message String
Event ID
FQXSFPU0021I The TPM physical presence state has been cleared.
FQXSFPU0023I Secure Boot Image Verification Failure has been cleared as no failure
in this round boot.
FQXSFPU0025I The default system settings have been restored.
FQXSFPU4034I TPM Firmware recovery is finished, rebooting system to take effect.
FQXSFPU4038I TPM Firmware recovery successful.
FQXSFPU4041I TPM Firmware update is in progress. Please DO NOT power off or
reset system.
FQXSFPU4042I TPM Firmware update is finished, rebooting system to take effect.
FQXSFPU4044I The current TPM firmware version could not support TPM version
toggling.
FQXSFPU4046I TPM Firmware will be updated from TPM1.2 to TPM2.0.
FQXSFPU4047I TPM Firmware will be updated from TPM2.0 to TPM1.2.
FQXSFPU4049I TPM Firmware update successful.
FQXSFPU4059I User requested to skip freezing lock of AHCI-attached SATA drives.
System UEFI accepted the request and will execute priot to OS boot.
FQXSFPU4060I Skipped freezing lock of AHCI-attached SATA drives.
FQXSFPU4061I Restored default locking behavior of AHCI-attached SATA drives.
FQXSFPU4080I Host Power-On password has been changed.
FQXSFPU4081I Host Power-On password has been cleared.
FQXSFPU4082I Host Admin password has been changed.
FQXSFPU4083I Host Admin password has been cleared.
FQXSFPU4084I Host boot order has been changed.
FQXSFPU4085I Host WOL boot order has been changed.
FQXSFSM0007I The XCC System Event log (SEL) is full.
FQXSFSR0002I [arg1] GPT corruption recovered, DiskGUID: [arg2]
FQXSFDD0001G DRIVER HEALTH PROTOCOL: Missing Configuration. Requires
Change Settings From F1.
FQXSFDD0002M DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
FQXSFDD0003I DRIVER HEALTH PROTOCOL: Reports 'Reboot' Required Controller.
FQXSFDD0005M DRIVER HEALTH PROTOCOL: Disconnect Controller Failed. Requires
'Reboot'.
FQXSFDD0006M DRIVER HEALTH PROTOCOL: Reports Invalid Health Status Driver.
FQXSFDD0007G Security Key Lifecycle Manager (SKLM) IPMI Error.
FQXSFMA0029L The [arg1] PFA Threshold limit has been exceeded on DIMM [arg2].
[arg3]
FQXSFPU0021G Hardware physical presence is in asserted state.
146
ThinkSystem ST250 V3 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning