Initial:
Immediately after the power is turned on, if one of the following
conditions are met.
When the machine recovers from the energy saver mode, if one
of the following conditions are met.
Done either once or twice (or not done), depending on
temperature change since the previous line position adjustment.
The machine checks the above conditions at power
on/recovery. Then, line position adjustment is done if one of the
conditions occurs.
Slide 127
No additional notes
Adjustment Conditions (1)
» Time after drum motor stops (SP3522-002)
» Temperature change since the previous line position adjustment
(SP2193-008/011)
» Number of prints (SP2193-016) since the previous line position
adjustment
» Time after drum motor stops or main power on (SP3522-002)
» Temperature change since the previous line position adjustment
(SP2193-008/011)
» Number of prints (SP2193-016) since the previous line position
adjustment
127
Di-C1 Training