Ricoh Di-C1 Manual page 123

Automatic Line Position Adjustment
d
d
LP 1
d
LP2
d
d
d
C
During automatic line position adjustment, the line patterns above are
created on the transfer belt.
Slide 123
The spaces between the lines are measured by the front, center, and rear ID
sensors. The controller takes the average of the spaces. Then it adjusts the
following positions and magnification.
Sub scan line position for CMY
Main scan line position for CMY
Magnification ratio for CMY
Skew for CMY
The transfer belt-cleaning unit cleans the transfer belt after the patterns are
measured. SC 285 shows if an error is detected three times consecutively.
Front C enter R ear
A
129 129
123
W 1
W 2
Di-C1 Training