Mercedes-Benz GLE 2022 Operator's Manual page 279

* NOTE Causing wear to the brake linings by
permanently depressing the brake pedal
Do not permanently depress the brake
#
pedal while driving.
To use braking effect of the engine, shift
#
to a lower gear in good time.
* NOTE Damage to the drivetrain and
engine when pulling away
Do not warm up the engine while the
#
vehicle is stationary. Pull away immedi-
ately.
Avoid high engine speeds and driving at
#
full throttle until the engine has reached
its operating temperature.
* NOTE Damage to the catalytic converter
due to non-combusted fuel
The engine is not running smoothly and is mis-
firing.
Non-combusted fuel may get into the catalytic
converter.
Only depress the accelerator pedal
#
slightly.
Have the cause rectified immediately at
#
a qualified specialist workshop.
* NOTE Reduced battery life due to frequent
short-distance trips
The 12 V battery may not be sufficiently
charged when the vehicle is used only for
short-distance trips. This reduces the life of
the battery.
Drive longer distances regularly to
#
charge the battery.
* NOTE Damage to the vehicle due to not
observing the maximum permitted head-
room clearance
If the vehicle height is greater than the maxi-
mum permitted headroom clearance, the roof
and other parts of the vehicle may be dam-
aged.
F167 0009 02
Driving and parking 277
Observe the signposted headroom clear-
#
ance.
If the vehicle height is greater than the
#
permitted headroom clearance, do not
enter.
Observe the changed vehicle height with
#
add-on roof equipment.
%
Please bear in mind that all the speed values
stated in this Operator's Manual are approxi-
mate and are subject to a certain tolerance.
Notes on driving with a roof load, trailer or fully
laden vehicle
When driving with a loaded roof luggage rack or
trailer as well as with a fully laden or fully occu-
pied vehicle, the vehicle's driving and steering
characteristics change.
You should bear the following in mind:
Do not exceed the permissible roof load and
R
towing capacity. Also observe the information
in the Technical Data.
Distribute the roof load and the load inside the
R
vehicle evenly, placing heavy objects at the