Table of Contents
Advertisement
No.
Procedure
Check
Remarks
21.
When the COPY START key
0
There should be no un-
glows green, make two cop-
usual noise.
ies of a single sheet docu-
0
The TONER OUT indicator
ment. Before making the se-
should flash five, seconds
cond copy, wait for at least
after the end of the sec-
five seconds after the drum
ond copying operation.
has completely
stopped.
22.
Open the front door. Pull out
the developing
unit to the
stop.
23.
Shake the toner cartridge
vigorously.
24.
Raise the cover of the develo-
ping unit hopper, invert the
toner cartridge
and insert the
two tabs at the end of the
cartridge
into the holes at
the rear of the developing
unit, lay the toner cartridge
flat, and pull it forward
slightly until it touches the
protrusion.
25.
Hold the toner cartridge
se-
curely and slowly pull off the
seal toward the front.
26.
Strike the top of the toner
cartridge to remove any
toner remaining
in the toner
cartridge.
27.
Remove the toner cartridge,
then place it in an empty box
and discard it.
28.
Close the hopper cover, then
I
push in the developing
unit
to the rear.
29
Swing the developing
unit
positioning
lever clockwise.
30.
Close the front door.
3 1.
Set the power switch ON.
32.
After the COPY START key
glows green, manually feed
six to ten sheets of blank
AB/Ledger
size paper
through the copier.
33.
Place a test sheet on the co-
Copying operation
should be
pyboard, make a copy, then
normal. If it is not nbrmal,
check the copy image.
make any required
adjustments.
I
_,--._
,,--
',
-j_
5-4
COPVOIGHT
0 IQ00
CANON INC.
CANON NP4015/1215S
REV.0 OCT. 1980 PAINTEU
IN JAPAN IIMPAIM~
AU JAPONI
Advertisement
Table of Contents
