Canon NP-1015 Service Manual page 60

2. Removing the Pick-up Rollers
3. Removing the Registration Rollers
1) Remove the U guide plate. (Refer to the
sub-section on removing the U guide
plate.)
2) Unscrew the two screws holding the
band of the manual feed tray.
1) Open the front door and remove the
developing unit and the drum unit.
2) Remove the U guide plate. (Refer to the
I'_ "
sub-section on removing the U guide
plate.)
3) Remove the two E rings, the tension
spring, and the two spacers.
@ Mounting screws
Figure 4-23
3) Remove the screws shown in the figure,
then remove each mounting screw.
@ Mounting screw
Figure 4-24
@ E rings
@ Spacers
@ Tension spring
Figure 4-25
4) Remove the rear cover.
5) Remove the clip retaining ring, then
'unscrew the screw, and finally remove
'the mounting clutch.
00 WFe;taining ring@ Mounting clutch
@ Registration roller
clutch
Figure 426
4-8 COPYAI6HT 0 IQ80 CllNON INC.
CANON NP-1015/1215S REV.0 OCT. 1900 PAIWTEO IN JfW IlMPAlMf AU JAPONI