Canon NP-1015 Service Manual page 65

~ 6. BLANK EXPOSURE UNIT
1
1. Configuration
,/ -\ ,
Figure 4-42
2. Preconditioning Exposure Lampboard
."-.\
1) Remove the rear cover.
2) Disconnect connector J73 1 on the pre-
conditioning exposure lampboard.
3) Grasp the lampboard with pliers, and
pull it straight out.
Note:
Take care not to damage the board.
~
3. Blank Exposure Unit.
1) Remove the copyboard glass, lens
cover, rear cover, and drum unit.
i
2) Remove connector J73 1 on the precon-
I
ditioning exposure lampboard.
~ @ Connector (J731)
I
Figure 4-43
~
3) Place a hand under the blank exposure
unit, unscrew the four screws, then
slowly remove the preconditioning ex-
posure unit from the front.
,,-, Note:
: 1'
Take care not to damage the developing
cylinder.
COPYRIGHT 0 IQ68 CANON INC.
CANON NP-1015/1215S AN.0 OCT. IQ88 PAINTELI IN JAWLN MlPillMf AU JAPONI
4- 13