Installing The Plug-In Module; Trigger - Agilent Technologies 54751A Manual

The Instrument at a Glance

Installing the plug-in module

You do not need to turn o the mainframe to install or remove the plug-in
modules. The plug-in module can be installed in slots 1 and 2 or 3 and 4 on
the Agilent 83480A, 54750A mainframe. The plug-in module will
if it is installed in slots 2 and 3.
To make sure the instrument meets all of the published speci cations, there
must be a good ground connection from the plug-in module to the mainframe.
The RF connectors on the rear of the plug-in module are spring loaded, so
nger-tighten the knurled screw on the front panel of the plug-in module to
make sure the plug-in is securely seated in the mainframe.
Do not use extender cables to operate the plug-in module outside of the
C A U T I O N
mainframe. The plug-in module using extender cables can be damaged by
improper grounding when using extender cables.

Trigger

The external trigger level range for this plug-in module is
source selection follows the slots the plug-in module is installed in. For
example, if the plug-in module is installed in slots 1 and 2, then the trigger
source is listed as trigger 2. If it is installed in slots 3 and 4, then the trigger
source is listed as trigger 4.
The maximum safe input voltage is
C A U T I O N
1-8
6
2 V + peak ac (+16 dBm).
FINAL TRIM SIZE : 7.5 in x 9.0 in
not
function
6
1 V. The trigger