In Case of Diculty
1. Make the following checks:
If the plug-in
does not
operate
2. Perform the following procedures:
5-4
Is the plug-in module rmly seated in the mainframe slot?
Are the knurled screws at the bottom of the plug-in module nger-tight?
Is a trigger signal connected to a trigger input?
If other equipment, cables, and connectors are being used with the
plug-in module are they connected properly and operating correctly?
Review the procedure for the test being performed when the problem
appeared. Are all the settings correct? Can the problem be reproduced?
Make sure the instrument is ready to acquire data by pressing
Find any signals on the channel inputs by pressing
See if any signals are present at the channel inputs by pressing:
4
Trigger
5
NNNNNNNNNNNNNNNNN
Sweep
NNNNNNNNNNNNNNNNNNNNNNN
freerun
After viewing the signal, press
Make sure Channel Display is on by pressing:
Channel
4
5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Display on off
Make sure the channel oset is adjusted so the waveform is not clipped
o the display.
If you are using the plug-in module only as a trigger source, make sure
at least one other channel is turned on.
If all of the channels are turned o, the mainframe will not trigger.
Make sure the mainframe identies the plug-in module by pressing:
4
Utility
5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
System config...
FINAL TRIM SIZE : 7.5 in x 9.0 in
.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
triggered
on
NNNNNNNNNNN
.
Run
.
4
Autoscale
5