Adjusting And Installing The Cutting Unit - Toro Greensmaster 1018 Operator's Manual

Adjusting and Installing the Cutting Unit (continued)
5. Install the coupler
driveshaft.
6. Install the reel-drive assembly to the cutting
unit.
7. Ensure that the coupler
back and forth on the transmission driveshaft.

Adjusting and Installing the Cutting Unit

Models 04830 and 04840 Only
1
1
1
4
1. Use 4 socket-head screws
cutting unit to the machine.
2. Adjust the traction drum for the desired height
of cut.
3. Adjust the cutting unit to your desired settings;
refer to the adjustment procedures in your
cutting unit Operator's Manual.
4. Install the coupler
drive assembly
5. Ensure that the coupler can easily move back
and forth on the transmission driveshaft.
Note:
the reel-drive-assembly position or the engine
and transmission alignment; refer to
Maintenance.
3460-879A
to the transmission
can easily move
Cutting unit (order separately; contact your authorized Toro distributor)
Coupler
Spring
Socket-head screw
and spring
of the cutting unit.
If the coupler cannot be moved, adjust
G403394
to install the
G403395
to the reel-
G403406
Page 3–2 Setup: Adjusting and Installing the Cutting Unit