Adjusting The Clip Rate; Adjusting The Traction-Drum Position - Toro Greensmaster 1018 Operator's Manual

Adjusting the Clip Rate

1. Determine the appropriate clip rate per the following table:
Clip Rate
Reel Speed
Low
Low
High
High
2. Adjust the reel speed control to the H
3. Set the reel-drive pulley on the cutting unit to the H
to your cutting unit Operator's Manual.

Adjusting the Traction-Drum Position

The traction drum can be adjusted to 2 positions:
• L position
OW
golf-course green).
• H position
IGH
golf-course tee box).
1. Move the kickstand to the T
2. Remove the shoulder bolts
the machine that secure the drum drive
housing to the chassis.
3. Align the holes in the chassis with the holes in
the drive housing.
4. Use the previously removed shoulder bolts to
secure the drive housing to the chassis.
5. Move the kickstand to the S
3460-879A
Pulley
Position
8-blade
Low 7.3 mm (0.286 inch)
High 6.1 mm (0.241 inch)
Low 5.9 mm (0.233 inch)
High 5.0 mm (0.196 inch)
: Use this position for mowing at a lower height of cut (e.g., mowing a
: Use this position for mowing at a higher height of cut (e.g., mowing a
RANSPORT
on each side of
position.
TORAGE
Page 5–4
Cutting Unit
11-blade
5.3 mm (0.208 inch)
4.4 mm (0.175 inch)
4.3 mm (0.169 inch)
3.6 mm (0.142 inch)
or L setting as needed.
IGH OW
or L
IGH
–W S position.
HEEL ERVICE
G404712
14-blade
4.2 mm (0.164
inch)
3.5 mm (0.137
inch)
3.4 mm (0.133
inch)
2.8 mm (0.112
inch)
position as needed; refer
OW
Operation: Before Operation