Toro Greensmaster 1018 Operator's Manual page 51

Installing the Cutting Unit (continued)
2. Remove the hardware that secures the reel-
drive assembly to the side plate.
3. Remove the reel-drive assembly, flat washers,
spring washers, and spacers from the side
plate.
4. Align the cutting unit to the frame.
5. Use 4 socket-head screws
cutting unit to the frame.
6. Use the previously removed socket-head
screws, washers, and spacers to secure the
reel-drive assembly to the cutting-unit side
plate.
Ensure that the reel-drive-assembly driveshaft
is installed to the transmission-driveshaft
coupler
Installing the Cutting Unit
Models 04830 and 04840 Only
1. Move the kickstand to the Cutting-Unit-Service position.
2. Align the cutting unit to the frame.
to secure the
.
G404920
G404921
G404922
15