Installing The Transport-Wheel Shaft; Installing The Transport Wheels - Toro Greensmaster 1018 Operator's Manual

Installing the Transport-Wheel Shaft

Model 04840 Only
1
Note:
The right-wheel shaft is installed at the factory.
1. Apply medium-strength thread-locking
compound to the threads of the wheel shaft
2. Thread the left-wheel shaft into the drum drive
assembly on the left side of the machine.
Note:
on the shaft end and has right-hand threads.
3. Torque the shaft to 54 to 68 N∙m (40 to 50 ft-
lb).

Installing the Transport Wheels

You can purchase an optional Transport Wheel Kit (Model 04123); contact your authorized
Toro distributor.
1. Ensure that the tires are inflated to 83 to 103 kPa (12 to 15 psi).
2. Move the kickstand to the T
3. Slide a wheel onto an axle
4. Pivot the wheel-locking clip
center of the wheel, allowing it to slide farther
onto the axle.
5. Rotate the wheel back and forth until it slides
completely onto the axle and the locking clip is
secured in the groove on the axle shaft.
6. Repeat the procedure on the opposite side of
the machine.
7. Carefully lower the machine off the kickstand.
Setup: Installing the Transport-Wheel Shaft
Left-wheel shaft
The left-wheel shaft is marked with a "L"
.
-W -S
RANSPORT HEEL ERVICE
.
away from
Page 3–3
G403407
position.
G407045
3460-879 A