Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine Owner's Manual
Certificate of Compliance
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Adjusting and Installing the
Cutting Unit
Parts needed for this procedure:
Cutting unit (order separately; contact your authorized
1
Toro distributor)
1
Hex tube
1
Spring
1
Collar
Procedure
1.
Adjust the cutting unit to your desired settings;
refer to the cutting unit Operator's Manual.
2.
Install the spring, collar, and hex tube to the
transmission coupler shaft
Description
Cutting unit (order separately; contact
your authorized Toro distributor)
Hex tube
Spring
Collar
Transport Wheel Kit (order separately;
contact your authorized Toro distributor)
Grass basket
CE/UKCA decal
No parts required
(Figure
3).
Qty.
1
1
1
1
1
1
1
–
Qty.
1
1
Read or view the items before operating the machine.
1
1. Spring
2. Collar
3.
Install the cutting unit to the machine; refer to
Installing the Cutting Unit (page
6
Use
Adjust and install the cutting unit to the
machine.
Install the transport wheels (optional).
Install the grass basket.
Adjust the engine speed (for use in
CE/UKCA-compliant countries only).
Acknowledge the traction-drum position.
Use
Figure 3
3. Hex tube
g307641
30).