Setup; Adjusting And Installing The Cutting Unit; Installing The Transport Wheel Shafts - Toro Greensmaster 1021 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Operator's Manual
Engine Owner's Manual
Certificate of Compliance
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Adjusting and Installing the
Cutting Unit
Parts needed for this procedure:
Cutting unit (order separately; contact your authorized
1
Toro distributor)
1 Coupler
1 Spring
Procedure
1. Adjust the cutting unit to your desired settings;
refer to the cutting unit Operator's Manual.
2. Install the coupler and spring to the
reel-drive-assembly of the cutting unit
Description
Cutting unit (order separately; contact
your authorized Toro distributor)
Coupler
Spring
Right wheel shaft
Left wheel shaft
Transport Wheel Kit (order separately;
contact your authorized Toro distributor)
Grass basket
(Figure
Qty.
1
1
1
1
1
1
1
Qty.
1
1 Read or view the items before operating the machine.
1
1. Coupler
2. Spring
3).
3. Install the cutting unit to the machine; refer to
Installing the Cutting Unit (page
6
Use
Adjust and install the cutting unit to the
machine.
Install the transport wheel shafts (Model
04840 only).
Install the transport wheels (optional).
Install the grass basket.
Use
Figure 3
3. Reel-drive assembly
g304658
28).